Isover Duo - Solution Page

Isover Duo Header

Isover Duo - Energylite® and Insulation Pins

Isover Duo - Energylite® and Insulation Pins

Isover offers a safe and energy efficient solution to comply with the legislation by combining the Energylite®'s thermal and acoustic comfort with the reliability of the Isover Insulation Pins.

SANS 10400-XA legislation mandates that all buildings with raised floors/soffits be insulated with non-combustible materials that have an R-value of 1.5 m2/K.w

Products

1. Energylite®

3. Isover Insulation Pins

Installation Guide
Isover Duo - Installation Guide 1

Set out on a clean soffit with chalk line markings measured at a 1200 mm x 600 mm rectangle (size of a Energylite batt). Additional markings to be made 300 mm away from opposite edges with a centre line at 300 mm through the short edges.

Isover Duo - Installation Guide 2

Place two pins at the points of interception on the centre line and make two markings through the holes of each pin for drilling. Remove the pins and drill into soffit at a suitable depth for anchor screws.

Isover Duo - Installation Guide 3

Place pins on soffit, push in the anchor screws and hammer in securely. Impale the Energylite® batts on the pins and lock in with the washers without excessive pressure to avoid compression of the insulation batt.

Isover Duo - Installation Guide 1
Isover Duo - Installation Guide 2
Isover Duo - Installation Guide 3